Prerequisites
You should have installed and configured Eucalyptus before starting the CLC.
To initialize and start the CLC
-
Log in to the Cloud Controller (CLC) host machine.
-
Enter the following command to initialize the CLC:
Note: If you are upgrading and you just restored your cloud data, do not
initialize the CLC; skip this step.
Important: Make sure that the eucalyptus-cloud process is
not running before executing this command.
clcadmin-initialize-cloud
This command might take a minute or more to finish. If it fails, check
/var/log/eucalyptus/cloud-output.log.
-
If you want the CLC service to start at each boot-time, run this command:
systemctl enable eucalyptus-cloud.service
-
Enter the following command to start the CLC:
systemctl start eucalyptus-cloud.service
-
If you are running in VPCMIDO networking mode:
-
If you want the eucanetd service to start at each boot-time, run this
command:
systemctl enable eucanetd.service
-
Start the eucanetd service:
systemctl start eucanetd.service