Show information about VPN connections.


euca-describe-vpn-connections [--format format]
	[--stylesheet stylesheet] [vpn_connection_ID [vpn_connection_ID ...]]


Option Description Required
vpn_connection_ID [vpn_connection_ID ...] Description. No
--format format Show connection information in the specified format.

Valid values: cisco-ios-isr, juniper-junos-j, juniper-screenos-6.1, juniper-screenos-6.2, generic, xml, or none

Default value: xml

--stylesheet stylesheet Format the connection information using an XSL stylesheet. If the value contains "{format}" it will be replaced with the format chosen by the --format option. If the value is an HTTP or HTTPS URL it will be downloaded as needed.

Default: value of the vpn- stylesheet region option.


Available Filters

You can add filters to your request so that the response includes information for only certain VPC connections. For example, you can use a filter to return only the VPC connection that has a specific ID. Some tips for using filters with this command:

The following are the available filters for euca-describe-vpc-connections:

Filter Description
bgp-asn the BGP AS number advertised by the customer gateway router
customer-gateway-configuration connection information for the customer gateway
customer-gateway-id ID of the connected customer gateway
state the VPN connection's state (available, deleting, deleted, pending)
option.static-routes-only whether the VPN connection is restricted to static routes instead of using BGP
route.destination-cidr-block the address block corresponding to the subnet used in the data center behind the customer gateway router
tag-key key of a tag assigned to the VPC
tag-value value of a tag assigned to the VPC
tag:KEY specific tag key/value combination
vpc-connection-id the VPN connection's ID
vpc-gateway-id ID of the connected virtual private gateway

Common Options

Option Description
--show-empty-fields Show empty fields using (nil) as a placeholder to indicate that this data was not requested. Empty fields are not shown by default.
--region value Specify region value as the cloud region to use. You can set this by using the environment variable AWS_DEFAULT_REGION.
-U,--url value Overrides the URL for the service call with the value entered. You can set this by using the environment variable AWS_AUTOSCALING_URL.
-I, --access-key-id value User's access key ID
-S, --secret-key value User's AWS secret Key to use.
--debug Prints what the command sends to the server and what it receives from the server. Use when you're trying to debug Euca2ools.
--debugger Enable interactive debugger on error.
--version Display the version of this tool.
-h,--help Display the manual page for the command.